1 5

CNC Voltmeter Selector Switch – Precise Voltage Monitoring

Rs.1,200.00 PKR
Rs.1,200.00 PKR
Sale Sold out
Type
AMPARE
In stock (50 units), ready to be shipped
  • Vendor:

    C Power

Description

  1. Overload protection
    2. Short circuit protection
    3. Controlling
    4. Used in residential building, non-residential building, energy source industry and infrastructure.
    5. According to the type of instantaneous release classified as follows : type B(3-5)ln, type C(5-10)ln, type D(10-20)ln

General

LW28 Series Universal changeover switch mainly used for AC 50/60Hz, rated voltage up to 380V and below, DC voltage up to 220V, rated current to 160A electrical circuit for manually infrequent making or breaking the circuit for the purposes of control and conversion ,can also controlling three-phase asynchronous motors and circuit directly as the purposes of master control and measurement. The products widely used, instead of the various national switch, can be used as the circuit control switch, measuring equipment switches, motor control switches and the master control switch,and welding machine switch and so on.
standard: IEC60947-3

Operating conditions

1. The ambient air temperature does not exceed +40℃, the average temperature within 24 hours and not more than +35℃.The ambient air temperature is not lower than -5℃ .
2. Installation site altitude does not exceed 2000m
3. The relative humidity of the air no more than 50% when the maximum
temperature is +40℃ and at a lower temperature allows a higher relative
humidity, such as when temperature is 20℃ the relative humidity reaches 90%.
4. Special measures should betaken for condensation occassionally due to temperature changes.

Selection

For use to master control

Note：If there are special wiring requirements, please provide the wiring diagram or contact us

Technical data

The following table shows the relevant dimension of the transfer switch

The following table shows the relevant dimension of the transfer switch